Regulator 12V for the marine engine
Serially the mono phase regulator for AC generator presents the best replacement for the diode rectifier. When achieves the required voltage on the accumulator regulator interrupts the rectification of entry voltage (the package half-wave). When the voltage falls regulator again switches on the filling also maintains the minimal voltage of accumulator in 0,1V accurately.
These versions of regulators are resistant to being able over voltage (to 180V) who could calls because the rosin connection on the accumulator or also because of detachments of accumulators. The serial regulator not was able will stop the filling until passes the cycle conductions thyristor. If the accumulator has the high impedance, will come to increases of voltages on him also exists the possibility that damage the second connected energy user. When speak about the state of accumulator here thinks on the total destroyed accumulator. Therefore, at the use this type of regulator, regularly control thin accumulators and clamps.
Electronics of regulators has been protected from the water and humidities with the poliurethane mass. Housing has been joined on the minus pole the output (the accumulator minus). Lengths of conduits from the regulator to the accumulator is not crucial, but would be better that is the regulator maximal 2m from the accumulator. In the event of the short-circuiting or the detachments of accumulator regulator not rectifies the alternating voltage with the generator. Testings on the ship have given perfectly the keeping of voltages of accumulators within limits 0,1V. By this have been used accumulators with the gel 12V / 130Ah.
Regulator was able will use and on motorcycles, but then comes in the attention am 30A the version with the reduced heat sink (the imperative air-cooling). Still the dimension of such regulator are 88 * 3525 * 100mm.
are regulated the output voltage of accumulator: 13,85VDC (Rset=100K), +4,5mV / °C
the maximal momentary voltage on terminals of accumulator which does not damage the regulator: to 150VDC
the minimal voltage of accumulator for the start fillings: 5.2VDC (at 25°C)
the maximal current: 10ADC permanently, 20ADC the 5 minute
ambient temperature: -25..+45°C
loss regulator: 0,6Ah / year
terminals: quality separable ordinal terminals for the current to 20A
dimensions: 100 * 50 * 50mm i.e. 100 * 65 * 50 with the connector
price: 285 HRK with VAT, guarantee 3 years (cover errors does not emerge because of the influence of humidity)
Give the discount on the larger quantity and further sale.
making with already joined conduits instead of the connector
making with the inseparable terminal
the regulatory voltage 13,7 / 14.3 / 14.7V according to the order
with the larger heat sink was able will increase current fillings to 20A
with stronger elements and larger heat sink for the all other current (e.g. 40A)
the three-phase making
Price for 30A the version: 550 HRK with VAT (dimensional is larger 100 * 50 * 150mm and with pulled out conduits). Down is the example 30A versions for the motorcycle (the installation on the spot with the draught). All elements are for 50A. Complex current weaker because of the smaller size of heat sink. I.e. regulator can rectify and to 50A, but you cannot guarantee the durability.